This product is made in the following way: base materials are firstly dipped into asphalt or
thermoplastic elastomer (e.g. SBS), thermoplastics (e.g. APP or APAO) and modified asphalt;
then both surfaces are coated with elastomer or plastic asphalt; fine sands and mineral grains (pieces)
or polyethylene membranes are spread or covered on its upper surface; fine sands or polyethylene
membranes are spread or covered on its lower surface.
It is widely used in waterproof and damp-proof works of roofs, basements, bathrooms and pools of industrial and civil architectures, waterproof, damp-proof, airproof, and leakage-proof works of bridges, parking lots, swimming pools, tunnels and reservoirs and maintenance works of
I , II
polyester felt(P), glass fiber(G), polyester felt with glass fiber(PG)
PE film, Fine sand, Mineral Particles / Pieces
2mm, 3mm, 4mm, 5mm
7.5m, 10m, 15m
1) Good waterproof performance. 2) High tensile and tearing strength, elongation and dimensional stability which accommodates substrate movement and deformation. 3) The product is suitable for building waterproof under low temperature conditions. 4) Anti-puncture and rooting resistant, fatigue resistant, anti-corrosion, mildew resistant and weather resistant. 5) Easily operate with hot-melting method, at all seasons.
Attention: 1) Do not operate when rain, snow, strong wind. 2) Train before operation.
Storage and Transportation: 1) Separate storage for different models. 2) Temperature should be below 50 ℃. 3) Avoid direct sunshine, rain, keep ventilated. 4) Do not piled horizontally, keep stand and not more than 2 floors.
Where to use:
1) Roof and underground in industrial and civil buildings, wall, toilet.
2) Bridge, subway, tunnel, swimming pool, etc.
3) Waste landfill, sewage plant, irrigation system, etc.
How to use:
1) Clean. 2) Brush foundation. 3) Heat surface of waterproof membrane with flame spraying equipment. 4) Roll waterproof membrane hard, edges should be covered at least 10cm. 5) Press waterproof membrane hard, make it be firm.
Packing & Delivery
WanMaiDe estabished in 2001, a leading manufacturer and exporter of Glass Wool, Rock Wool, Rubber Foam, Foam Glass,Extrude Polystyrene/XPS, Phenolic foam board insulation in China. After more than 20 years' development, we totally have 10 producing lines for glass wool insulation,5 producing lines for rock wool insulation and more than 30 producing lines for rubber foam insulation.
We had mad OEM production for WANMAIDE which are popular due to the high quality and competitive price all over the world.